42-Lights Modern Chandelier LED Light Fixtures Adjustable High Ceiling Long Light Chandelier for Hallway Foyer Dimmable Lights with

Beautiful chandelier! The 12 lights give plenty of brightness, and the modern design looks stunning in the room. Installation takes some time, but the result is worth it. Read more

The quality is excellent and it truly elevates the look of the room. Installation was smooth, and the design is stunning in person. My entire family loved it — we’ve received so many compliments already. Highly recommend! Read more

We just hung ours and we love it. Reading the reviews was really helpful. We laid it out on the kitchen table and measured the distances w Between the light. They’re numbered for you on the housing. Then we tied them all up while mounting the housing and made sure it worked before installing. It was a a good thing we did because there was an simple issue with the wiring. Added the crystals last of course. It look beautiful. Really added a lot of characters to the foyer for a very low cost. Read more

Amazing lights… everyone in our home starts to compliment as soon as they come in. We love it Read more

Safety hazard! Fixture professionally installed 2 days ago. This morning full crystal fell from 20 feet and landed in my foyer! That could have caused a serious injury - is this an issue anyone else has experienced? Read more

Lindos incredible perfectos para cualquier espacio Read more

All good. It does take 3 to install because of ceiling height. Read more

The directions tell you to mount the fixture and then adjust the wire length if needed. Don’t waste your time following the instructions and installing the fixture before adjusting the wire lengths if you know you’ll need to do that. Adjust the wires on the ground then mount. Why? Because it took 2 hours to adjust the wires and many of the wire clamp fittings did not work well. My fingers are still raw and numb 2 days after trying to adjust the 12 wires while it was mounted. Here’s how my install went: 1) hang fixture. 2) discover wires are too long. 3) try to adjust wires while fixture was mounted. No success after 1 hr. 4) remove fixture. 5) measure and adjust each of the 12 lights and adjust wires using one hand on the back of the fixture to pull hard on the wire and another hand on the outside of the fixture to release the wire clamp. 6) hang fixture (don’t wire) to test for correct height and spacing of the 12 lights. 7) remove fixture and make several small adjustments. 8) wire fixture and mount. 9) ice my fingers from the pain these wires caused and how hard it was to adjust. Note I had a medallion from the previous fixture that I cut to fit this chandelier. The medallion is not included. Otherwise, the light looks amazing and works well. The remote is convenient. Lots of different settings for kelvin color and brightness. Love the end result but it was a painful challenge and difficult install 14’ in the air. Read more