Great faucet for a good mix of function form and Cost
This is an excellent choice for a budget bathroom faucet that will give you the advantage of a pull down in a smaller form factor. The sprayer aerator has a soft mode and what I’ll call cleaning mode of spray and the selection switch moves back and forth well. And fav thing i haven’t constantly hit the selector on accident when I pull out the sprayer to get a mouth rinse and blast myself in the face like I do in the kitchen pull down faucet. The neck is good enough quantity to handle the light use of secondary faucet, it’s lightweight but not low quality. the neck and base are strong and moves very smooth in a full 180. The stem and valve have excellent flow through and lots of pressure, so I was right my old faucet’s GPM was crap. The Handle* has got a nice satisfying ease of movement and with the right amount of resistance or firmness to it. No slop or wiggles. The design is really good looking, ascetically pleasing and is high enough with enough length to get the reach to get the water to flow right at the drain, and not splash back behind the faucet onto the sink. The finish is consistent throughout and the brushed nickel matches all my other brushed nickel stuff except. *I handle quality is actually attributed to the stem quality so when I swapped out the stock handle that has the post style, for one in the pic which is one I had on hand and just preferred, it still functions perfectly because of the inner hardware. So yes the stem is a standard size and there’s a set screw and it can be swapped if you happen to have a drawer full of handles like I do. CON: These complaints are for 90% of faucets I buy, fix, install; so they are applicable but they shouldn’t be considered negatively against this model. So even though the majority of people will never notice these nitpicks- I do, and I will keep complaining about it till the industry improves, so I guess forever. 1.The Handle, it is a post and screw into the round stem cover screw in style and I personally hate the style. My kitchen has a middle /high end moen and it has it as a one piece molded post type and I hate it too. There too small and weird to clean. Next. 2. Supply lines aren’t verified and can’t pass inspection. If that’s not a problem for you then also they’re too thin-walled and hard to put a tight loop in or bend without causing kinks. And the compression fittings are lower quality and than I like. PERSONALLY-I’ll only use supply lines that are verified by an independent organization have the ratings and certifications on them and will be up to national and local plumbing code. They’ll have to be able to pass a building inspection if I’m gonna use them. No matter the project. They’re a few $ more but you can reuse them on any faucet and theyll last for like 10 years. Also you won’t have to worry about them bursting in the middle of the night. Read more





























