Bones Big Balls Reds Skateboard Bearings 8 Pack

Big balls big speed, great ride, silent, smooth, they roll on and in Read more

Very smooth ride for the price. Read more

I bought these to replace a set of reds I've been running for about a year that have worn out and gotten loud. I mainly skate swimming pools so speed is helpful. When I first put these on the board and rolled down my driveway I thought they were slower than the old reds, kind of felt that way. But after a couple sessions I've already noticed that I'm going a bit faster in certain parts of my runs without extra pumping or anything. Its just retaining speed better and seems to get to a higher speed rolling down banks than the old bearings. They sound very quiet although they had a subtle clicking noise when I first put them on and spun them, on every bearing. Not sure if its my trucks or what but it was definitely noticeable. Its still there when I free spin them but I dont notice it when skating. Whether they last longer than the reds only time will tell. So far I'm happy with them, a definite upgrade over my worn reds. Can't remember if fresh normal reds were as fast when new though, I feel like these big ball red are faster. Read more

I skate even faster on the sidewalks outside now. These are smooth, quiet, and come factory lubricated. They are excellent on my Bont Parkstar Quad skates. Highly recommend. Read more

These are a remake of the bones Swiss 6 bearings, but for a budget. Of course these aren't as good as the original but are high quality. They spin meh out of the box but broken in well. Cannot beat the value for what you get Read more

I can tell the difference from my used wheel bearings to these within the first 20 ft or so. I feel like the new wheel bearings I go about 3 to 5 ft on a pump these I go about 5 to 7 ft every pump. And slightly smoother too. Read more

love ❤️ 😍 these Read more

I have been skating boarding for almost 30 years and I run Bones Big Balls on all my push boards now because these have fewer defects than other bearings. Very good bearings for the money, not Swiss but for those you pay more obviously. These bearings are very fast and are better quality than Bronson G3 bearings period. When you install these in your wheels use two drops of speed cream and ride your board for about 14 miles to set the bearings, the speed will increase and the bearings will last for years. I set bearings with a dust seal on the inside of the bearing as well as the outside dust seal to keep the lube in the race, then remove the inside seal, clean and re-lube the bearing whenever you want. I would not recommend these skate rated bearings for Eboards. I have three Eboards and the weight and speed of my MetroBoard Eboard can create too much heat for a skate rated bearing, speed rated bearings should be used in Eboard wheels. Read more