Works Where a Seat Would Not
I bought the Kohler Purewash M300 seat with built in bidet to install in my half-bath. That toilet has a Moen Brantford flush handle that sticks out a little too far for the Kohler seat to go past vertical soi t would not stay up. I also could not adjust it more forward without it sticking out past the bowl. That seat was reinstalled elsewhere and I ordered this Brondell SS-250 as a replacement. Installing the Brondell was as easy as installing the Kohler. The plumbing went on easy, required no tools, and it does not leak anywhere. While I was prepared to use the included Teflon tape, I didn't need it with hand tight connections. I only needed a screwdriver to take off and reinstall the seat. This attachment is quite thin. The front bumpers of the toilet seat are now just a hair off the bowl so it makes a slight "tick" as it contacts the bowl when you sit on the seat. I doubt you would even notice it. I think the look of the integrated seat is slightly more polished but this does not look bad and it works where a seat would not. Functionally, as mentioned in many reviews, I can't imagine anyone needing more pressure than this attachment can deliver. If you go straight to full power, it will take you off the seat. Its the same toilet, same water pressure as with the Kohler seat so the difference has to be just a more concentrated stream. In any case, I love the cleaner feeling from using a bidet than just TP. You will, too! Read more




















