UPDATE: Cleaner Air Better Health Unvelivable (Almost)
I just received this unit two days ago and placed it in my new home office/studio. First, it is a bit noisy, but all blowers make noise or they wouldn't circulate air. I placed it in the far corner and set it on "Auto" mode which is advertised as the setting that controls the unit - according to the quality of air in the room. Here's where it gets very interesting. I have a globe bulb lamp in my special studio that is opaque inside with a glossy surface outside. It's quite beautiful and diffuses the light perfectly. After about a year, the globe had a 2" round dark spot inside so I had to remove and clean it. The challenge with the cleaning is that the globe drys water-spotted inside so I use Isopropyl alcohol to rinse it eliminate spotting. I reinstalled the globe which was obviously still wet (inside) with alcohol... which I allow to self dry. Lo and behold, the air cleaner turned Red and went into Turbo mode all by itself. The lamp globe was 3' away and on top of a 2' table and the cleaner was on the floor. I timed it and it ran 34 minutes before returning back to low speed auto mode. The sensor worked! BTW: I like the "white" smell along with a minor "white" noise...all good. Update: The Pre-Filter (I bought a pack of 4) is not the "T" filter which is what I wanted for pet odors and VOC removal. After way too much time searching herein, I had to go to Honeywell site and buy one there...$36. The "T" filter fits against (in front of) the main White filter so, altogether to obtain the ultimate filtration, this unit must have Three (3) filters installed. Read more








