Lab Vibrator 4 Oscillator Round Shaker Plaster Vibrator Plate Dental Equipment Machine for Mixing 110V 100W

This has been incredibly useful for my cement and plaster work. I make countless figures and need the mixture to reach every part of the mold, and this vibrator works perfectly for that. It's very easy to use. Its motor is powerful, and the machine stays put during use thanks to its non-slip feet. Plus, it's simple and straightforward to turn on, with no complicated settings. It works perfectly for various projects or small batches of materials. Read more

I’m so glad I got this lab vibrator to clean my electronics. I regularly clean out tough clogs of specialty inks from my electronics. I had a tough clog that I worked for a week soaking in various solutions with little effectiveness. After placing a unit on the platter in a Pyrex disk, I slowly turned the dial up to an acceptable level. Within 20 seconds it completely cleared out a clog that soaking for 7 days straight couldn’t do. Maybe soaking loosened it all up, but I needed this tool to vibrate it all out. Can’t wait to use it again. Read more

I ordered this vibratory lab table for the loading of TSS shotgun shells for turkey hunting. Several of my favorite load recipes call for buffer mixed in with the shot, this vibratory table fit the need perfectly! This also works great for 100%+ case capacity rifle loads where you need to condense the powder as much as possible before loading the projectile. I’m sure it would work just fine for lab needs also. I have already recommended to several of my fellow reloading buddies who have also purchased this product and are very satisfied with it as well. Read more

I use this for making plaster positives of dental agar negative impressions for my family. I make my own dentures and my family's dentures. This vibrator works flawlessly in removing the bubbles in the plaster molding process. Make sure your plaster is soupy like a thick but watery pancake consistency. Then, when you mold up the impression, hold it firm to the base of this vibrator for at least 30 seconds. The goal is NOT to vibrate the mold, but to vibrate the liquid PLASTER. Hold the impression tightly to the vibtator base for at least 30 seconds. That works great for me. For the cost, I recommend this. Vibrate the plaster, not the mold! Hold the mold tightly to the vibrator base! Read more

This is ok but not what I was expecting. I was expecting more vibration at the lower setting. Still using it. Read more

I was using this for getting the air bubbles out of the plaster I used for making "grillz". I took the impression from my client, mixed up the plaster, poured it, and the results sucked. Lots of imperfections and cavities from trapped air. So I ordered this. It has a full range from light to super violent. Needless to say, using this bad boy and a toothpick to poke in each negative tooth space really got me some amazing results. Which resulted in an even better white gold grill. Read more

Great for vibrating bubbles out of stone or plaster for projects or dental lab purposes. Read more

Arrived and wouldn't turn on. I opened it up and the cheap board has multiple faulty solder points also the ground wire was just bouncing freely unattached rubbing against the live wires that were soldered and only wrapped with cheap heat shrink... stay away from this product. It's dangerous and extremely cheaply made. Read more