VEVOR Water Distiller 1 1 Gal Distilled Water Machine 750W Pure Water Distilling w BPA Free Plastic Container

This is actually the 2nd VEVOR distiller I am purchasing. I purchased my first one almost 2 years ago and it is still working like a champ even after I accidentally dropped it and the bottom plastic cracked on it. I use this to distill my water because I do everything possible to get my water to be H2O and nothing else. Distillation, for me, is a key step in this process. Setup is a breeze there's not much to it really just the reservoir, the lid, and the 1 gallon jug the distilled water goes into. There is this metal spout that you're supposed to put on top of the water jug, however, I highly advise against using that. I had it happen where the spout from the lid and the metal piece on top of the jug were not aligned properly and it resulted in water leaking everywhere. I tossed that metal piece into a drawer and just make sure the spout is aimed correctly so the water will drip into the jug. The jug has a really big hole so it's not terribly difficult to set it up without the metal guide piece. If you're going to use this in your house I would suggest putting in a room that is as far away from where you wish to be as possible because this thing will generate a lot of heat for the around 4 hours it takes to distill a gallon of water. My suggestion is set it up in a garage or something like that. Although a lot of stuff gets removed from distillation there is always some stuff that gets into the finished product as some contaminants have the same or even a lower boiling point than water does, so I suggest using some kind of filter afterward. I use a Zero Water filter for this. It does come with some cheap charcoal filter packs that you're supposed to install in the metal spout of the lid, but those don't seem to do much. I've noticed that without using the zero water there's a certain smell and taste to the water that isn't awful, but it's just odd and if I use the zero water that is removed. Sometimes I'll even filter the water before distilling it and then again after just to help keep the distiller clean. This brings me to the next thing, cleaning out all the gunk left behind. They give you a little bit of cleaning powder which is actually just citric acid. I got 2lbs for about $15 on here and it lasts me about a year. Could last much longer if you don't distill a gallon or two a day like I do. To clean this things you put the water a little higher than you see stuck on gunk and then just add in a tablespoon at a time while boiling the water with the lid off. Wait 20 mins if there's still a lot of stuck on gunk add another tablespoon and wait another 20 mins until you can see it's all clean. That's really it, this thing is very easy to use and like I said I've had one for over 2 years now so from what I can tell VEVOR makes a quality product and everywhere else I've looked for a distiller usually tries to charge $100+ for a basically identical device. Do not let the cheap price scare you away this thing is quality and will get the job done reliably for the foreseeable future! Read more

This water distiller is easy to use and maintain. The distillate is so pure it leaves no residue in my CPAP water tank. It paid for itself quickly. It looks well made and functions exactly as it should. The fan's exhaust is comfortably warm, at a good temperature for warming fingers and decrystallizing honey. On the down side for some, it's a large device and there is some noise from the relatively quiet fan. Helps to have water and electricity at hand. It meets my needs quite well. Read more

Takes about 4 hours to distill the full volume of the included jug (4 hrs 7 min the one time I tracked it). Came with the activated carbon packet pre-loaded in the dispenser nozzle. The instructions tell you to soak the packet in water for 5 minutes before using though, so I took it out to do that and put it back in. It's easy enough to pop the nozzle out and back in. The included instructions are not very good. Lots of text (kinda rough translation), few pictures (and they're small). But, the unit is self explanatory enough. Fill the chamber with water to the fill line, put the head back on, connect the power cable between the head and the base, turn it on with the jug below the nozzle and wait. You have to press the reset button between uses to start it off again. CAUTION when removing the head / refilling. It can be hot (it's steam after all) and I found that there's a bit of pressure that builds in the chamber, so some water sprays out when removing the head after it's finished. If it doesn't spray out, it'll drip from the head when you remove it. So there's some cleanup involved between uses. Leaves behind a black sooty gunk in the bottom of the chamber after it's done (if that's what's in my tap water then yikes lol) - I've just been wiping up what I can with a paper towel between uses. Despite the downsides, it does what's advertised and for a reasonable price. Yay for no longer having to buy gallons of distilled water from the store. P.S. - I have no idea what the metal spout lid is for (in one of my review pictures). It's not threaded so it doesn't fit onto the provided jug. 🤷 Read more