BED SCRUNCHIE Sheet Holder Straps - Heavy Duty Gripper Clips - Strengthened Parachute Cord - 360 Degree Bed

I was hesitant to try this due to the price, but after trying a few less expensive sheet holders that were basically useless, I broke down and bought the bed scrunchie. Like the saying goes, you get what you pay for, it works like a dream, worth every penny! Sheet stays put with two tossing turning people and two big dogs all night with no problem. Easier than expected to put on as well. Read more

Years of fighting mattress pads and sheets sliding away and taunting me every morning as I start my day with a 30 minute corner to corner tug of war. No more This is the answer to all the cussing and disgust with beds left unmade out of sheer frustration only to greet the mess in the evening. Less than 5 minutes to make up my bed and start my day! I have a top sheet that no longer wraps around my neck and leaves my feet out in the cold. Great product! I’m kinda irritated I didn’t think of it. 5 stars all the way Read more

Product works great! My only complaint is it's a little difficult to get on and off the bed. Read more

I can't attest to the longevity of this product, but I will gladly sing the praises of this item. If you want to stop fighting lumps and ripples all night, buy this. I had no problem installing it on a queen mattress with a topper on it. Directions were easy to follow and components are good quality and well made. So far, so good! Read more

The only issue I had was with the Strap having been twisted(like a mobius), which made it more difficult to use than likely intended, but I am talking to the seller about it. Even then it did not take longer than an extra minute or so. Easy to attach, quick to tighten, even easier to remove. Just flip the mattress and unclip, or walk/climb to each corner and easily unclip them while lifting the mattress. Easier to use that Metal Alligator clips or straps. Does not damage sheets. Affordable and reliable. EDIT: Keep getting the run-around with their customer support. Either ignoring what I am saying and the photo's I send, or outright brushing me off. Contacted them, was not responded to until the next week. Then they did not respond. I tried the Chat on their website, the agent responded, then when I tried to explain the problem I hear nothing from them for 3 hours. Then they state that I should stretch it out, as if it was just the cord being wound up, and not a defect. I stretch it, take pictures, send them. another 2 hours later (started at 11, they responded at 12:30, I responded at 1, they responded at 4:59), they message me back saying that they do not see a problem. This is with the photo's. So I try sending higher quality photo's, pointing out that a mobius will ALWAYS wind itself up into a twist. It is a defect. I even point out it is not a terrible defect, I am not upset, I would just like to know if I can get a replacement scrunchie, or and extra or something, as the defective one make it unneccessarily difficult, and since it is obviously not a problem that I caused, I'd like it fixed. I am not responded to, then I find that their work hours end at 5pm. So the support chat person waited to the LAST POSSIBLE MINUTE to respond and then left me in the chat. I shot a complaint about it to their cantact us email, included a copy-paste of the chat-log, and a request about a resolution of the problem. The SAME PERSON from my chat log responded to this complaint, with an email, stating that maybe I should buy more clips to get rid of the twist. Ignoring that the problem is BUILT IN, and more clips will not really get rid of a defect in the cord. You can see in my photos the twist is a defect. The cord was twisted once when it was made/attached. So at the drawstring, on either side, the side that is up on one is the bottom side on the other. Causes a Mobius, with twists up the entire cord when taut and released, as this is a bungie cord. Difficult Customer Service. Read more

Had my husband put his 200+lb body on this puppy. If you sleep on a board. the sheet isn't likely to wrinkle under your weight. That is plain common sense and physics. Compression reduces volume. However, when you remove weight from a compressed object, it returns to its former size hence the sheet becomes taut again. It may be my imagination, but the mattress seems firmer. That doesn't affect my comfort level, however. Bed Scrunchie seems to do the job for me at this point. Read more