EVIL ENERGY 2 5 Inch Exhaust Clamp Butt Joint Band Clamp Sleeve Coupler Stainless Steel for 2 1

The EVIL ENERGY 3.5" Exhaust Clamp is strong, durable, and fits perfectly on my exhaust pipe. The stainless steel construction feels high-quality, and it holds mufflers and catalytic converters securely without any rattling. Installation was straightforward, and it provides a reliable, long-lasting connection. Overall, this clamp is a solid choice for any exhaust repair or upgrade — highly recommended! Read more

2.25” fit and worked perfectly on my 2010 Dodge Avenger 2.4L. I wasn’t sure if it would make an air-tight seal, so I wrapped the pipes with high temp exhaust tape before putting the clamp on. Read more

Great quality and fit great! Read more

I think the concept of this exhaust clamp is right on. I just think the actual band is flimsy. It should be a little thicker gauge when tying up, especially on an exhaust white pipe going into the main pipe for the rear to the muffler. I think that it’s a little bit of a pitch. It doesn’t fit tightly around the pipe you’re joining as others have written. They’re using a muffler paste, / sealant to seal without leakage on either end of the clamp if it was a stiffer metal I think it’ll be a much better fit so other purchases of this are correct you will have to put an exhaust high temperature cement sealant around the inside of the clamp if not you could get exhaust leakage Read more

Easy install. The suspension arm weld rusted out and broke a hole in the exhaust, so I needed this sleeve, plus another clamp with a hanger for the full job. Wrapped the whole area in exhaust wrap first then installed both. Worked great. Read more

We have gotten 3 of these so far. We have used 2 of 3 so far. When we went to replace the muffler with a new style and size of muffler, we had to get a pipe extension to connect the muffler to the catalytic converter. We bought the first one to connect those two parts and it did exactly what we needed it to do! It fit perfectly, its nice and secure. The second one was to connect the muffler to the pipe that we had to get to be able to connect the resonator pipe. The third one doesnt fit the resonator pipe as snug as the muffler pipe, so we are going to keep it for if we ever need another. We plan on getting a different style of this to finish the exhaust the way we want it. Read more

Not to bad i had a hard time getting them to tighten down enough to where the pipes don’t move. At one point I thought that it was going to break because of how much I had to tighten it in order for it to actually secure. The quality isn’t to bad. Pretty light, and the length is pretty good over all not to shabby but might be a better option out there. Read more

Awesome. This worked perfectly Read more