Great camera. Install straight forward but tricky.
Chose this camera so that I would not have wires hanging down for power. Quality of everything looks really good. Plastic and shape match original close enough. Mounted the rear camera on the passenger side. Ran the wire down and along floor instead of overhead. This was due to mainly my ability to get wire in behind trim, as the overhead route seemed more direct but was tighter between the headliner and trim pieces. Had just the right amount of wire so i will credit that to luck. The short adapter wire for power plugged in and was easy to tuck in/around existing hardware/mirror. The only problem was getting the new camera and plastic snapped back into place. I worked on this three different times, quitting when I would get tired ( having to lean over and work above your head takes a toll after 10-15 minutes). As others have stated in their reviews, it appeared to me that the four tabs that are inserted back into the truck are fatter than what comes original. I finally took the piece back off and verified it. I measured tabs at .060” versus .105-.110” thickness. I believe they would go if you were sure that everything was lined up and you forced it. But it was kinda cold and I was afraid to. I used a Dremel with a small metal deburing bit to just lightly remove the sharp edges and round everything off. Probably didn’t go below .100” on any of the four tabs. Returned to truck and plugged wires back in. Found the rear passenger side tab, as it was the one I could see and got it to snap right in. After a slight wiggle to make sure everything was lined up, the other three popped right in place. I then clipped in the smaller rear piece behind the mirror stem and I was in business. Had no problem finding or hooking my iPhone to camera. Overall, I am happy with purchase and would recommend others purchase it, provided they are patient for any problems encountered due to out of spec parts. Read more




















