Power Adapter Charger Cord Compatible with Ring Stick Up Cam Battery Plug-in 3rd Gen 2nd Gen Ring Pan

I bought the Stick Up Battery Cam and set it up pointing through a window. The live feed worked fine, but motion detection didn’t pick up anything outside. When facing inside, it worked perfectly, but through glass, it detected nothing.....until I purchased this wired kit. At first, I thought the camera was defective and almost bought another one. After researching and troubleshooting, I realized the issue was the setup mode. If you configure the camera as Battery, it runs in low-power mode and won’t detect motion through glass. Once I purchased this wired kit, reconfigured it as Plugged In (wired), motion detection worked through the window immediately. Your camera is not broken, it is just setup wrong. *Important note: you’ll need the wired kit if it didn’t come with your Stick Up Cam. Once plugged in, it works great and the cord length is long enough that it didn’t deter me from placing the cam exactly where I wanted in the window. Problem solved!!!!! Read more

Perfect length for my backyard camera and works perfectly with the Ring spotlight Read more

This does work but returned because of an error. You have to switch your Ring Device to Battery not direct wire or vice versa Read more

Works as it should no complaints Read more

It work for me Read more

As advertised Read more

I don't understand the good reviews, or maybe I just got a design defective unit. While the plug is the right diameter for a Ring Stick Up Cam, the plug is a touch too long. The back of the plug doesn't fit snugly into the circular depression, leaving an approximately millimeter gap that will allow water/elements to get in. It is the same for the USB that plugs into the power brick; it doesn't snap all the way in, and there is a slight gap that leaves about a mm of the USB plug exposed. The camera I purchased this for is in a garage, so weather is not particularly an issue; however, I am concerned about the safety of the exposed plugs. Additionally, I'm kind of concerned about the actual power load and safety for the battery. My camera was charged to 97%, and within seconds of plugging it in, it jumped up to 100%. It came with no instructions or information about the unit, so I don't know if it will just kill the battery by overcharging. I don't recommend this at all. I should have purchased the Ring branded charger. Read more

Great Read more