Questech 8 Corner Shower Shelf Retrofit Shower Organizer for Tile Walls Corner Caddy Soap Dish Bathroom Storage Geo

These are very sturdy shelves that hang fantastic with the recommended epoxy. They made a huge improvement to my shower and allowed me to get rid of the ugly over the showered hanging shelves. Custom look. Read more

I got a 5" and this 8" shelf. Both are installed and look great. I used JR Weld epoxy rated 4400 psi. The 5" stuck and stayed with no effort. But as the corner is slightly out of square, the 8" was trickier. The fit problem was so light that adding an adhesive tab over- corrected. So when I first put the shelf up, it kept slipping on one side, even after I held for several minutes (set time for epoxy was 5 min). So I used some painter's tape to hold it in place, and after an hour (the cure time for the epoxy) it was fine. I caulked and everything is great - now several days later. Read more

I was pretty reluctant to try a glue on shelf for a tile bath but have to say I’m pleasantly surprised. The shelves themself are great quality, some sort of dense material, who know what. Note, you’ll need a full tube of 5 min Gel epoxy for EACH shelf! I had to run out and get more because I way underestimated. Thankfully I did a test first and discovered this so no harm. To install, I decided to go off their script a little bit and drilled a hole on each side of the shelf glue face (sides that actually glue to the wall). Then I drilled two holes into the tile in the same locations and epoxied in small 1/8” dowel studs. Figured most of the weight will be pushing down so these would help tremendously with that load. You can see on the pics I uploaded the blue tape is for the drilled holes. ALWAYS use tape to drill into tile. Keeps the bit from slipping off and scratching. This is important too, tape everything! I taped the shelves and the wall tile so no epoxy could get onto anywhere it wasn’t supposed too. Yes, you can clean off epoxy if your fast and have the right stuff, but why bother, just tape it and be done. After everything was taped I put the leveling tape on the shelves and loaded on the epoxy to the glue surface. Once lined up with the dowels I just held it there for about 5 min until it was set enough to hold itself. Then IMMEDIATELY take the tape off! If you wait too long to remove the tape the epoxy will set too hard and you’ll have to cut it out, not that I did that, several times, just saying. After that I waited two full days for it to absolutely set, then caulked the glue seam and let that set again. Remember, epoxy likes to be warm when it sets. Good to go. So far they’re working great, they’re fairly small so only a bottle or two on them at once so should last a very long time. If something changes I’ll update the post. Good luck! Read more

These shelves made all the difference in my bathroom shower. No more falling shelves based on suction cups! I waited over a month before reviewing this to make sure they were as good as I thought and they are amazing! Extremely well crafted. Great instructions. I followed them to the T! I’m so happy I found these products. And they look fantastic. Totally look built-in. 2022 update—- I’ve had an issue where one year later the shelves fall. I would then carefully clean the back of the shelves and the wall and use epoxy again, the epoxy gel suggested. But each time after about a year the epoxy gel seem to soften and lose its grip So I called the manufacture of the epoxy and they told me that the gel is not waterproof. And will turn soft overtime and should never be used in the shower. They said to use their marine grade epoxy but that epoxy is not a gel and I would have to let it sit after being mixed for a period of time, watching carefully, as it slowly thickens and then apply it. I called the manufacture of the shelves and they were totally unaware of this issue. So on my last repair I used the marine grade epoxy and followed their instructions and put the shelves back in place. I’m much more hopeful this time that the shelves will stay put. But due to this experience, I downgraded my five stars to four stars. Read more

Had a tough time with the installation, will get a tiler to come and do the install. Read more

I'm always cautious about using tape to install things so came up with a better solution. Your going to need a miter saw and hot glue gun to do this. I took a scrap piece of wood and cut it into the shape of the tile. I then was able to hot glue this into the exact position where I wanted to corner piece to rest, I followed the grout lines. I then used JB Weld epoxy, it's the stickiest and strongest stuff I've worked with. I was able to forgo the use of the double sided sticky pads for this so after I put the epoxy on I simply put it on my temporary hot glued shelf and pressed it into the corner and then let it sit for 24hrs. To remove the temp shelf I used a screw driver, put it through the drain hole and tapped it with a hammer until the hot glue let go. You'll want to make sure the shelf is secure before you do this, my first attempt I heard a klunk as I was preparing the epoxy and it had let go by itself, I was in a hurry and didn't let the hot glue get as hot as it needed to be. Read more

Ordered this product and a 5” soap shelf and a 10” bottom shelf. Mounted them using Devcon poly gel. One 5 oz tube of Devcon was JUST enough to mount all 3 shelves. My shower is really out of square but the materials provided (plus the Devcon that I provided and the silicone shower caulking that I also provided) made the end result perfect. Expensive (all three shelves totaled over $110.00), but well worth it. Read more

Hello! I'm extremely upset with this product. Four shelves were purchased from Amazon on July 20, 2021 for a renovated bathroom that was done by a contractor in August 2021. The shower was used at most three times a week from September 2021 through March 7, 2022. It was then used again daily from September 2022 through October 28, 2022. As you can see the paint is coming off the shelf. The product is defective. It looks like the shelves were only painted or dipped in paint not a solid product. I paid $156.84 for these shelves. How will you resolve this issue? Thank you. Read more