RHINOCATS 400Pcs Small Magnets 4 Different Sizes Tiny Mini Magents Multi-Use for Fridge DIY Office Hobbies Crafts and

Thank you for your honesty! They measure about 1.96mm thickness, which is super close to 2mm! And thanks for the vinyl touch in the packaging:) Will buy again later (probably in bulk). I suffered from very bad tolerances on other listings, they were much thinner than listed, but this is actually accurate and honest. Glad I found it! 🥳 Read more

These tiny little magnets pack a punch despite their size, Four shapes, four strengths—each one a classroom prize. They’re perfect on my whiteboard, holding papers strong and tight— Strong, small, dependable… they keep our charts just right! For teachers needing power in a magnet that won’t fall— These RHINOCATS are mighty, though they’re really very small! Read more

I use these 6x3mm as embedded magnets for 3d prints. They are quite strong. The size is slightly off by 0.1mm across batches, but for the same batch they are consistently sized. Read more

These tiny magnets are exactly what I needed for my handmade clay refrigerator magnets. They’re small but surprisingly strong, and they hold up heavier pieces without slipping. The size is perfect — discreet and easy to attach with glue. Great quality and very reliable for craft projects! Read more

Use them in 3d printing and they function well for that. They appear to be dimensionally accurate, though I didn't check all of them, just enough to double check. Packaging leaves something to be desired, mine showed up in a metal box with foam leaving a big ball of magnets to go through. They stick together and stick to metal, so they work, not the strongest but they are small so, not really anything against them. Read more

Packaged really well, I’m not sure if the reviews that said these aren’t packaged well are old posts and they’ve updated since or what but they exceeded my expectations. These are perfect and at a fraction of the cost the hardware store had! They’re tiny and strong, really geat assortment for all of my 3d printed gifts : ) Read more

Very useful sizes for my 3D-printed boxes! Read more

I purchased thes to install on my N-scale steam locomotives. I run a lot of older 4-4-0, 2-6-4, 0-6-0 steam engines on my layout. The assoted sizes alow for finding the right strength and size to glue to my undercarraige of the loco. Of course they wont work without having something to attract to so I also install a thin 0.025 piano wire in the center of my track. This is installed in areas that have a grade or where there is difficulty with traction in pulling a realistic number of passenger, freight, or ore cars for the given engine. Not many of these steam engines can do much without some means to increase traction. The magnets are unseen and provide a downward force on the traction wheels which indeed helps the pulling power and effectivness of the locomotives. My track was already layed but if you are installing new you may find it resonable to install strips of light steel sheet that can be cut with shears and placed under your track to provide for the attaction. This system will work for most any scale just size accordingly to the size needed. By the way Amazon also proovides the small piano wire in differnt lengths. I used 36-inch. Read more