VERY bright lights
I ordered 20 of these for my 42' x 50' shop that has 20' ceilings. During installation, I tested one light in the loft area and was shocked at how bright one of these is. I immediately decided not to install two of them and use them in another area. Once 1/4th of the units were installed on one end, it was apparent I would not need two more that were planned. I could have had very good lighting using just 10 of these units. My unites were mounted directly to purlins in a steel building. I have half the lights on one switch and the other half on another switch. Using only the lights on one side, it is like daylight in the shop and there are no shadows. The color is white and there is not color distortion. I have the lights grouped in pairs using the couplers provided. The electrical wiring was done using the direct wire cords provided and some of the switch cords with the switch removed. I also installed two of these in a 15' x 15' office and, like the shop, I split them between each side of the room. It very bright and perfect for use for amateur radio operation and work on electronics. I think the brightness and color specifications are right on. The units will get warm when in operation. The metal back of the light is a heat sink and being in contact witm metal beams, they will operate cooler. There is not audible sounds or flickering and no noise in audio devices. These have been installed a month so I have not comments on how long they might last. The mounting was done with the metal clips at each end and one plastic clamp in the middle. This will make it simple to replace should the need arise. I have no problem recommending this product at this time. Read more
























