VIVO Aluminum Articulating Dual Monitor Arm for 13 to 30 inch Screens Desk Mount Tension Spring Monitor Stand

Pros: easy to set up, has 2 screws to mount as opposed to one, which is very important for sturdiness. Had no issue mounting a 27" and 24.5". Monitors don't droop unless user error so ignore reviews that say they do, you just have to read the instructions properly on how to tighten them. Others with similar features are upwards of 30USD more. Cons: range of motion isn't perfect, could use 2 more inches of reach on each arm. Outside of that it's perfect for a cheap dual monitor arm with two mounting screws. Read more

Very good quality on this item EZ installation for all parts . Note, The tools that are provided are Allen keys they work well for basic assembly, these monitors are 32” On the default setting the springs didn’t hold up a chance and they were dropping down to the desk every time , I used the Allen keys they provided but the dials for the - & + resistance felt really tight with the small Allen key provided and was hard to turn into a tighter resistance. I proceeded to just go ahead and use another set of Allen key set with a handle that I had in my tool box, it provided me with a much better grip to spin the resistance dials , I had to spin the tool about 15-20 times to get it into my best resistance position one you spin the dial enough you can test for the desired resistance of the spring and position of monitors. Overall I’m very happy with this product, I purchased more after this buy for my additional work stations. Good luck. Read more

The VIV0 102-0 dual monitor stand is a decent buy for its price. It supports dual clamp/grommet which provides a secure installation as opposed to single clamp/grommet arms. The arms are made up metal and feel sturdy. They also look good. I bought it to support 2 monitors and free-up some desk clutter. I have mounted it by using the grommet mount as my desk has a frame came in the way of the clamp. Mounting the arms were easy. The instructions are precise and crisp and the arms were up and ready on my desk in about 15 mins. I have 2 monitors. The monitor on right is a 24" HP monitor that weighs 6 lbs. That monitor took to the arm like fish to water and I needed no specific arm or mount adjustment. Also, I can swivel, tilt or raise this monitor without any issues. The monitor on the right is a 27" Acer monitor weighting 10lbs. I had some issues mounting that monitor. Though the pneumatic arms hold good after a few adjustments, the monitor tilted downwards. I had to basically crank up the tilt to maximum to a point that the monitor does not tilt any more. I can still raise the arm and swivel the monitor without any issues. If I loosen the tilt bolts, the monitor just tilts face down. I think the advertised 14lbs weight capacity is over rated. May be it can support heavier monitors with some loss in functionality. The cable management is decent. It uses clips and they can come loose. I didnot have issues with it personally but I felt better cable clamping solution would have helped. The arms also go up a decent height. its not an issue for me as I use these monitors while sitting. It may be of concern to people who stand and work. The monitors also stick out a bit. Be advised that if the desk is set flush with the wall like I have, there is no way to bring both the monitors together. The only way is to set the desk far away from the wall so that the arms can extend beyond the desk. Overall, for the price, I would give it a 5*. However, due to the flimsy tilt clamp which has basically become non functional, I can only give a 4* (wanted to give a 3.5*) Read more

Very good product and great customer service. It took a little while to figure out how to install, but after reading the instruction manual it wasn't too hard. Had an issue with one of the arms and contacted customer service and was sent a replacement no questions asked. Great customer service. Very good build quality. I have been using the mount for a couple of months now and have not had any problems. supports my large monitors well and has tightening screws at multiple point on the mounts to ensure that your configuration is sturdy and stays in place. Read more

If you haven't Vesa mounted a monitor before you may not know how much better life is with these handy tools. My work has been from home for a while and having a functional desk, clean and organized has always been a passion. Unfortunately I had 3 monitors in the house that didn't have Vesa compatibility so it was never something I thought about seriously. Furthermore for some reason my impression was that they were expensive and hard to install. My set up was just a 27 inch monitor from my company (some 9 year old heavy garbage VA) and my laptop. When my son started getting into gaming I bought myself a 25 inch 144hz monitor to tie into my set up so we could play together. Things started to get messy on the desk 3 different sized monitors and bases etc. The company monitor and the new one had Vesa mounting though. So when I started to look at prices for these things I was shocked at how cost effective they are as well as easy to install. Well after about 10 minutes of setting it up and making the adjustments for the weight of the monitors, it just worked perfectly. I can't believe how nice and easy the things work. In fact I liked it so much that I installed one on my son's desk and bought special adapters to add Vesa capabilities to his set up (HP IPS monitors almost all of them don't offer Vesa at least the ones I have from best buy) When I see a monitor on a desk now, all I want to do is Vesa mount it. If you are even remotely on the fence about these, pull the trigger and get them. They are easy to use, cheap to buy and look fantastic!!! Read more