New Blender Cup and Blade Replacement Parts 32oz Cup and Extractor Blade and 2 Rubber Gaskets 4-Piece Compatible

This works perfectly, fits my nutribullet, and the replacement rubber rings fit to perfection. Read more

After having broken one of the insertion tabs on the original cup, we ordered this set, and are very pleased with it. We even swapped out the extractor blade housings. A very good buy at a very good price. What's more important, though, is what caused the tab to break. It was becoming difficult to attach the extractor blade housing onto the cup. The cup would not bottom out at those insertion points, so to allow the cup to be twisted into the on position. One of the more "obvious" solutions was to push down harder on the housing. Wrong. Doing that resulted in breaking one of the tabs on the cup. After unplugging the base, I tried to push down on the 3 white plastic tabs on the inside of each insertion point. Using a finger to push, they were resistant to being depressed. After some gentle coaxing, I got all 3 of them to move down as they should. The resistance could have been caused by gunk. I pushed each down repeatedly. While they were in the down position, I sprayed some dry lubricant inside the channels, again working them up and down. Problem solved. If anyone else has had this problem, this is an easy fix, and over in 90 seconds. Might not be a bad idea as a maintenance thing once or twice a year. Read more

Excellent quality items. The 32 ounce container is a little top-heavy for a neutral bullet unit, but that’s to be expected. Read more

First - I used one of the extra gaskets to replace an existing Nutribullet original gasket that was in need of replacing. Fits PERFECTLY!! The new gasket is a tiny bit snug and does need to be held in place as it’s stretched around the ledge but it fits as expected and does not leak!! 👍👍 It only took a couple of tries to perfect a hold-and-stretch seamlessly every time (because I now remove my gaskets to clean under them EVERY single use). Secondly - I put the new blender cup and blade attachment to use. I was pleasantly surprised to find the new cup is a bit larger than my original cup (which makes blending my usual morning smoothie seem to blend smooth a little faster). My DISLIKE is that the shaft on the blade attachment has about 1/4” of travel to it (up & down) vs. the original which is fixed and stationary. So far (after a handful of uses) it does not leak and has not caused any noticeable problems. I have concerns that with time this may become a failure point - but so far it grips the turning gears well and works as good as the original Nutribullet blades. Read more

Works great! Only drawback is the lid sometimes gets loose and contents leak around the seal during the blending, need to watch and check the seal during the process. Read more

I love it, it works very well! Read more

Brand new sharp blades Read more

Blade and cup wouldnt stay shut together, literally spilled oat milk all over my floor twice thinking I didnt tighten it right the first time whole time theres a defect with the cup and blade Read more