TechOrbits Standing Desk Converter-32-inch Height Adjustable MDF Wood Sit Riser-Black 32

I had searched over a year to find the perfect adjustable desk or desk top lift for my work station. As I have dual monitors, and an ergo keyboard, as well as wanting to keep the monitors further back, meant I needed something that was deep and had a larger keyboard space. When I found this, I had measured and then hoped that it would work. I will try to breakdown everything for those on the hunt like I was.. hopefully this will make the decision easier. The good: - Both monitors fit and are stable. - The keyboard tray is not under the unit much so I am able to continue to sit and stand ergo without having to back up from the desk (as most cause) with the monitors being too close. - The keyboard tray is wide and deep so it accommodates the larger keyboard easily - The lifting of this is assisted, and only has 1 lever on the right side. You still need to use a bit of muscle to raise it, but it is much easier than with no assistance - The height is fully adjustable, meaning you can lower it all the way down where the keyboard is on the tray and the tray is on the desk/table top, with monitors lifted, and you can go all the way up and can stop it at any point along the way. This means it works for people of different heights, or if you are wearing different types of shoes that make you taller/shorter without having to adjust your body to work with this - This came in a white color, which was a bit more rare than I imagined, so it looks good with my white desktop - This is very sturdy, not that you can lean on it, but everything stays in place and doesn't wobble when you type - Putting it together was easy. It comes with the keyboard tray off, and gives you step by step instructions how to install it, and it was perfectly pre-drilled and ready The con's: - The keyboard tray is not movable to go in and out. this means that if you install this so the keyboard is off the normal desk, it will always be further out and you cannot adjust it in when you are done or do not want it that way - The design (like most) is a rectangle, and when you sit with a corner desk, this takes some of the space away. This meant extra measuring, as well as losing some space - The monitors are still closer than the edge of the desk. If you are like me, and you have your monitor as far back as possible, they will be closer to you. On a plus side. this one had the deepest base and for my monitors, they are only about an inch closer than they used to be - The keyboard depth is still not far enough away. To make up for the closer monitors, I have had to put a bit of a "tray extender" under my keyboard so it can sit a bit further out so I can stay ergonomic when I sit. - There is not enough room for the mouse to have good movement. With a smaller keyboard, this would not be an issue, but as I use an ergo keyboard and have it in the middle of my sitting area, the mouse (on the right for me) has hardly any room. I got a separate mouse pad that locks onto a desktop to try and compensate. but there is not enough clearance for it to sit either attached to the lifting area or elsewhere to stay ergo. If you use a moving mouse, and need a lot of room, this would probably be an issue with any desk lift, and this is (due to it's size) going to be a better option than most. Overall, I am very happy with this purchase, and with my little adjustments have made this work very well for me, and now stand for half or more of each of my days... and as we know, that is much healthier than sitting. I have also recommended this to some of my co-workers who, like me, wish to stand more or need to have the option to sit or stand through their day. If you need something good in size, depth, is easy to install, sturdy, is able to be at any height... and is not too hard on the pocket book, this is an awesome choice! Read more

This standing desk converter is exactly what I was looking for. I was gifted a walking pad and needed this to be able to walk while working. Assembly was super quick and easy, mainly just installing the keyboard tray. It is easy to raise up and down. I like that it moves fluidly and can stop at whatever height I need it to. The only thing I don't like is that the keyboard tray protrudes too far out for my desk so I ended up removing it. Even still, I am able to work with my laptop, monitor, keyboard and mouse all on the main desk surface with no issues. Read more

This desk converter is working out well for me. It's easy to change positions from seating to standing. It would be even easier if i didn't have a heavy all in one desktop computer on it, but still there's just a bit more effort to raise it up at the start. Once it begins to go up it rises easily. Going down is a breeze. You can place it at any height just by taking your hand off the lever. It was very easy to install the keyboard shelf. It seems very sturdy. I wouldn't want to move it from room to room or travel with it because for me it's on the heavy side. When lowering the converter none of my wires get caught underneath. It's made in a way that prevents that. In the lowest position i do have to raise my desk chair a few inches so that my arms are level with my keyboard. There is a slot on the top shelf where you can put you cellphone which i find helpful. Read more

TLDR is the summary at the end. I like this one. Its not super fancy by any means but it more than gets the job done. The 37" width is good for dual monitors (I have two 24" HP's). The weird little phone slot is unnecessary but kind of nice, it wouldn't work with thicker phone cases but my work phone (Iphone 11 XR with Otterbox Commuter case) and personal phone (Samsung note 8 with Spigen case) fit it just fine. Things I like: -The 37" width makes the keyboard tray wider so I can have more room for my mouse/notepad on the right and somewhere to set a phone or drink on the left. -It comes with little foam pads for under the keyboard tray so you don't slam it down on the desk when lowering. -Fully adjustable height, stop it wherever you want. -The top is plastic coated so you could set drinks and stuff on it without much of any issues from condensation. -Its heavy enough to not move around on you and feel like something but not so heavy you can't pick it up and move it (someone thats a little weaker might have some problems moving the large 37" version around if you had to move your office or something) Things I don't like: -There really is no elegant cable management. There is a slot in the phone tray for a charger. There is a little metal bracket to keep your keyboard on the keyboard tray that also has some cut outs for cables. And they give you a couple zip ties and sticky cable manager things. That's about it. Just get some 1/2" velcro if you buy this and cable manage yourself. -Its a bit wobbly, although that might just be mine. We have others of this brand in the office and they don't seem as wobbly as this one. I thought maybe it was because this one is larger (which could still be part of it) but I noticed there is a ton of slop in the tracks attached to the top, I plan to take it apart to try and make some adjustments when I have the chance. Possibly just a quality control issue. -I wish there was a way to set a stop on the maximum height so I can easily go to my certain height easily. My Issues: I have had to order two of these. The first one arrived and the entire top was cracked in half. This was strange because the exterior box was undamaged. I noticed that the packaging does not protect the top very well anyways so I assume that one of two things happened: either the product was damaged in shipment but due to the poor packaging design it didn't really damage the box OR a bad top got through quality control. First one was returned for refund only for some reason, although I decided to give it another shot and ordered it again. The second one arrived complete, in working order but has a pretty bad minor defect that got through quality control. Little background on how the top appears to be made, it just looks like MDF with a textured hard plastic wrap molded over it where there is one flat peice on the bottom of the top and one piece over the top of it that wraps down over the sides. There is anywhere from a 1/16" to 1/8" gap all the way around where the two pieces are supposed to meet. You can clearly see the MDF underneath. It is also peeling away in the little oval holes where you grab it to lift up/push down. The peeling was already there when I pulled it out of the box. TL:DR / In summary: It seems to be a pretty good product for the money if it lasts but unless you get lucky with the quality control right off the bat, you may have to return a few to get a good one so if you are in a hurry do not buy this. Read more