TempPro Indoor Outdoor Thermometer Wireless 500 ft Outside Thermometer with Cold-Resistant Sensor Outdoor Thermometer Waterproof for Patio with

Good product, I brought it for my elderly parents, it's easy to use, the numbers are big enough. Good value for money. Works fine. Read more

Great product. Well made and really accurate. Does what it should! Read more

The first thing I did was set up home device and sensor next to each other. After half an hour, I expected the two temperatures and two humidity readings to be about the same. The temperatures are but the humidities are NOT. Same place different results. Advertises humidity +/- 3%. I was expecting them to be consistently off - i.e. both off by 3% in the same direction. Assuming actual humidity is exactly in between these two readings, then they are both off 3.5% in opposite directions. I'm not returning because I needed to replace my indoor/outdoor thermometer and thought for a couple extra dollars I get humidity too, but I was hoping for the accuracy stated. Still, humidity varies so much this isn't a big problem. I like: the back light; the ability to see both indoor and out door temps and humidities at one glance; and the ability to have either daily Min/Max or "whatever" timespan Min/Max. The face is a little cluttered, but readable. Also, temperature to 1/10 degree is not helpful when accuracy is +/- 2 degrees; the extra digit just adds clutter to the screen. Useful, reasonably accurate device. Thanks, Dan Read more

I was surprised how good this unit is after a month's use. The only feature I'm not sure of yet and which could affect future review is battery life, but so far it is much better than the Oregon Science unit it has replaced in that: • the sensor transmits easily from outside one end of the house to the room completely at the other end and through metal siding; the last unit could not do that • While initially I had the sensor indoors right next to the receiving unit and the indoor and outdoor temps differed by a few degrees, I found this was from handling the sensor. The difference went away with time. Outdoors, the sensor sends a temperature which is within one half degree of my expensive and accurate Davis Vantage View weather station. The two devices are in someone different places in the yard, one in sun the other not, but on cloudy, calm days when the readings should be the same, they are • The contrast on the display makes it very easy to read. The display unit is relatively small but the digits completely fill the whole screen and are readable from across the room • The backlight works very well with a tap in the center top of the display • The max-min feature is not explained well in the manual but works this way: you reset the max-min by holding that button for 5 seconds, then there is another button that gives you the choice of showing the max-min temps from the last time you did a reset or the max-min temps within 24 hours of that reset. So if you reset at 11:58 PM and use the 24 hour choice it gives you the max-min since the last 11:58 PM and then starts all over for the next 11:58 PM. It counts 24 hours internally. There is no clock. If you choose the “all time” setting instead of 24 hours, the max-min never resets and you will see the max-min since the last time you reset which could have been a month ago. The unit only operates in one of the max-min modes at a time. If you set it to "all time" you cannot display the 24 hour value. • The only”con” I would register is that there is no beep or other indication that the max-min reset has been successful. You can check to see if the max-min are both the current temp when you do the reset, but a beep would be nice. Read more

I use this thermometer in my greenhouse and monitor is in my house. It takes the heat of summer and works through the winter. It is very helpful in tracking what my plants are experiencing without constantly running to check. It is small enough to not use your valuable plant area Read more

Works well! Easy to set up, good value Read more

I like these TempPro wireless thermometers. They are easy to read and work great for a while. I am on my third one now. The outside sensor dies after about 18 - 24 months. A replacement sensor is available for ~$15 and a whole new unit and sensor are available for ~$19. So I just buy a whole new unit after the 18 - 24 months. Read more

The Temp Pro unit works well for us: 1. It will display as F or C. The humidity info is helpful too. 2. Display unit has a stand for table use or a magnet attachment. Both work well. Transmitters use a screw slot to hang up. 3. The display unit will handle up to three transmitters: channels 1 - 3. 4. You can track trends in temp and humidity both indoor and out. It will also give you min or max numbers. 5. The display is easy to read; it lights up with the top button. 6. Display and sending units use two AA batteries each - inexpensive. This is recommended. Read more