VIVO Full Motion Dual Monitor Desk Mount Clamp Stand VESA Double Center Arm Joint Holds 2 Screens up

So for me, installation was easy enough, although I ran into a slight problem pretty early. The provided thumb screws for the VESA mount were a little too long for my 24-inch monitor, so I had to use some small nuts I had lying around to fill in the gaps (I didn't have any washers). Not a big deal, but it could be an issue for people who don't usually keep that kind of hardware on hand (if they run into the same problem). Everything about the mount feels solid. It's almost completely composed of metal except for a few plastic caps and clips. It mostly has no trouble holding up my two monitors. I say mostly because it did have a little trouble keeping my 32-inch from tilting forward under its own weight. I had to REALLY tighten the hex bolts to keep it held up properly. A little tip for anyone planning on getting this... if you have your desk against the wall, be sure to set up your cables before mounting your monitors. It never really crossed my mind while I was working on it, but I wish I knew to do that before hand. I ended having to unmount my panels to set up the cables, then remount them, which took extra time and effort. Overall I'm very happy with how everything turned out. Having two monitors has been super useful, and I love that it doesn't actually take up too much more desk space with this mount. I'm very glad I bought this and I would recommend it for sure. Read more

Got one as a gift to myself, set it up within 30 minutes. Found a ton of space on my small desk that I couldn't use before due to the monitor stands. Now, the monitors move so easily that depending on what I'm doing, I can be closer to the action without worry. Just a heads up so it doesn't surprise anyone, but the tilt locks are not fully factory tightened, one of my heavy monitors tilted before I had a chance to grab the Allen to lock it and surprised me. No harm because I had the lock nut in the back of the monitor already. Probably done so it's not over tightened by the factory and hard to loosen or retighten back up. All in all, wonderful product, great quality for the price, and I had to s get a second set for my wife because she liked how much space it gave. Read more

Please ignore my messy desk. I was able to use this stand and modified my desk to drill holes and lift it through my riser. The stand is mega sturdy and comes with built in wire management at the top back end of the mount! It's also got clips that follow the arms as well. Now if only I could apply the same wire management care to the bottom of my desk Read more

I wanted to host 2x32-inch flat panels on a desk that's about 2 inches thick. I didn't have a lot of space available behind the desk (it sits against the wall) so chose this style as it seemed to be fairly flush, and also keep the monitors at the back of the desk. Initial set up took maybe 15 minutes - no more complex than basic Ikea furniture assembly, fix part A to part B using screw C. Instructions weren't marvelous, but easy enough to follow along. When I first put the monitors on the arms, one of them was sitting about an inch lower than the other. No real obvious issues, and no trouble shooting in the manual. Took me about 10 minutes and a spirit level to figure out the adjustment. I'd put one monitor on before the other, caused the arms to dip towards that side, needed to take both monitors off, level the arms, and really crank down hard on the nut holding the horizontal arms to the vertical riser. Might have been easier if I'd had an assistant to get both monitors mounted simultaneously, but a little brute force solved the issue. I have a slight angle between the two 32-inch panels - they're maybe at 170 degrees rather than completely flat. There's enough extension space remaining on the arms that I suspect holding 34-inch panels would be fine. Overall, I'm pleased with the look - cleans up my desktop a lot, and lifts both monitors to a higher position than the stands they came with. Of course, I only assembled it a couple of hours ago, will update if anything changes over next few weeks. Read more

Good stability, I've used it with a 34" curved monitor and a 28" (I think, I've moved and that one is still in storage) and its held up great. For my needs, it could be a little taller, but the specs are available. Looks great, and is rugged. I've lost some of the screws, so here's to hoping there common size/thread pitch. Owned for 2+ years. Read more

Great looking monitor stand that works well with my big monitor as well. Read more

This went together great with the instructions. Some of the screws to keep the screens from swiveling were hard to tighten but held everything in place well. Biggest thing for me was that I could not get my 26" monitors close together because the arms kept hitting the wall behind my desk. Fortunately...all of the screws and parts were interchangeable, so I was able to remove half of one arm and re-attach the monitor mount and it no fits my screens perfectly! Read more

Would NOT recommend! I installed two screens and it was not sturdy at all! When the screens were installed on the mount, it was close to the desk, which defeated the purpose. I wanted to put items under the mounted screens. Safe to say, product was returned. Read more