Great Pull-Up Bar, Solid, Easy Install
This is such a great pull-up bar, which is easy to install, and it's very strong. It comes with six expansion anchors for mounting into concrete size M10x80. I installed this by myself in about an hour and here are a few tips for doing it yourself: Tools: Hammer Drill, Ladder, Pencil, Level, Hammer, Crescent Wrench, Vice Grips or Channel Locks. 1. Measure your desired area to understand the bar in anchoring layout completely before installing anything. 2. Mark the top anchor hole for one wall bracket only, then drill the hole. 3. Set the top anchor temporarily with the wall bracket attached, then mark the remaining two holes of the wall bracket. 4. Drill the remaining two holes of the wall bracket. 5. Install the wall bracket set the anchors. The anchors should be pre-installed onto the wall bracket. 6. Hold the bar up to the wall with one end abutted against the installed bracket and mark the other end, which will be the location of the next bracket 7. Repeat the bracket installation steps indicated above. 8. Install the bar. I mounted mine with the bolt heads facing inward toward the bar, so the nuts were on the outside so as to avoid miagrabbing any bolt projection. 9. Snug-tight, as defined by AISC, is all that is needed. Do not over tighten these bolts or you will compress the hollow square brackets. I would expect installing onto a wood stud substrate will be similar process. Read more






















