Sunco Linkable LED Shop Lights 4 Pack - 7 Inch Wraparound Garage Ceiling Light 6500 Lumens Commercial Industrial

Bought these lights to put in our back yard garage. The garage was not electrified originally and these lights are GREAT! They are nice and bright. I also had them replace all the lights in our 3 car garage and they and great. You have 3 brightness settings. All are set on the brightest setting except one. I had the one by the house entrance turned down one. It is still plenty bright, but not so blinding when taking my dogs out during the night. I would recommend these to anyone. Read more

I order this 4 pack of lights to see test installation, light intensity, color heat etc for a major church project. I installed the first 4 lights from this and was immediately impressed with all of them. To the point I just ordered 4 more 4 packs. and will order have at least 2 more 4 packs needed. Price, installation, delivery are all good. I particularly like and recommend the fact that if you want they supply fittings so you can daisy chain the lights. In my case removing an 8 foot fixture and replacing with 2 of these 4 foot fixtures I just used the mini daisy chain connector that kept the two lights only a 1/4 inch apart with no extra fittings or wiring to buy. Read more

I installed these by myself and found it to be very simple. I located the place in the room that I wanted them to go and I put a single 65 lb anchor into the drywall and screwed the light fixture Center into that anchor. There is a hole already provided for that. What it allowed me to do was adjust the lamp from front to back until both sides were equal distance from the wall. Then I marked my four spots and spun the light fixture on the single mounted screw exposing the four marks that I had just made and I put four anchors in the ceiling. I then spun it back into place and anchored it down and it turned out perfect. I wish the lens fit a little more securely in the box but it wasn't bad enough to deduct any stars I thought this product was perfect for my garage application. I will buy two more so that they stretch most of the length of my three car garage. I'm very happy with them. Now I just keep my fingers crossed that 50000 hours for the lamp life is accurate. Read more

Used them for a new Classroom in our Church. They are bright and easy to install together Read more

The garage is well lighted using four ceiling mounted 4’ fixtures for general illumination. Each fixture has dual 4ft T8 LED bulbs. Each easily replaceable bulb uses 15W and produces 1800 lm, or 30W, 3600 lm per fixture. The Sunco fixtures use LED strips that would not be that easy to replace and consume 50W (67% more than the existing ceiling fixtures), but 81% more light. These American made Sunco fixtures are thankfully very BRIGHT and well worth the asking price. Reviewers of other competitors complained about how fragile (breakable) the plastic lens covers were, but these from Sunco are not. What is needed is task lighting over a work bench and under a cabinet. Not from a junction box as shown in the instructions but mounted to shelving and plugged into a receptacle. Since up to six of the Sunco fixtures can be combined end-to-end, I opted for a 14/3 extension cord, cut to length. To mount/protect the extension cord, a rubber grommet could be used but I wanted to use a round cable strain relief bushing to prevent any cord movement. Specifically, a 7N-2 Round Cable Strain Relief Bushing. The Sunco supplied wire nuts were used to join the fixture wiring to the 14/3 extension cord. To provide a switch for the light, I chose the Cable Matters Grounded Outlet with Switch from Amazon. One small issue with the Sunco fixtures as manufactured. The linking cables (1.5" and 8") DO NOT FIT! That is, on all cables the 3 male pins only engage with their female counterparts by about 1/32 of an inch instead of the intended ¼ inch. Even with significant pressure the cables could not be forced to engage. My solution was to carefully drill each female hole to increase its ID to match the male OD. I used several ever increasing diameter numeric drill bits until I had success with a #42 drill bit (0.0935” OD). I suspect a 3/32” fractional bit (0.09375) would accomplish the same task. Read more

Great lights. Went up easy. The corners were damaged a bit, but nothing a pair of needle nose pliers couldn't fix. Better packaging would resolve the issue. Could see the wiring through the diffuser but 2" white duct tape takes care of that. Bought another pair. Same damage, same fix, but the lights are great! For a shop or garage these lights work well. I would buy them again. Update: Purchased more for the Barn. Worked great! Love the 6000K Read more

I used this product in my garage. These lights are fantastic. They are extremely bright. The quality of the product is far superior than what I expected I would get. I would recommend this product to anyone and everyone that wants to put surface mounted LED lights anywhere in their home or garage or shop. Ben Read more

Have only installed two of the four. Was easy to install. The only hard part was deciding on what sitting I wanted. Read more